Skid Plate Brass Weight Assembly (10mm) 424g

Racers have been asking for weights since the RetroBuster was released to help with the down low weight and help get to the 9lb minimum most clubs have in place.

This is the first batch of weights I have machined.

This assembly is made out of 10mm H90 Brass and weighs around 424-429 grams (.882 lbs).

I can not source this brass in large enough quantities so after these are gone, all weights will be made out of 3/8" 360 Brass.

This does come as an assembly and is bolt in ready.

If the braces to not match up with the holes in the chassis, loosen up the bolts on the top of the brass and connect to the chassis.   These weights have about 0.2mm of play and can bow the braces. 

Loctite is recommended.   

Batch #2 will try addressing this issue and anything else we encounter.

Tags: clodbuster, chassis, racing weights